PVDF and the EU PFAS Restriction: How to Test the Polymers That Could Replace It

PVDF is one of the most widely used polymers for microfiltration and ultrafiltration membranes, and it is a fluoropolymer. Under the broad PFAS definition used in the EU's proposed universal restriction, it falls within scope. Membrane makers and researchers are therefore looking hard at what could replace it.
Where the restriction stands
According to a European Parliament briefing from July 2026:
ECHA's risk committee adopted its opinion supporting the restriction on 3 March 2026.
The socio-economic committee agreed a draft opinion on 10 March 2026 and plans its final opinion by the end of 2026.
The European Commission will then draft the restriction, which goes to a vote of member states and scrutiny by Parliament and Council.
Fluoropolymers are in scope. Where derogations are granted, they are time-limited, for 5 or 12 years depending on how soon substitutes are expected, and come with site management plans. Nothing is final yet, but the direction is clear enough for development work to start now.
The candidates
A review on The MBR Site explains that PVDF is caught because it is made from PFAS building blocks. It names polyethersulfone as a likely short-term beneficiary and notes a trend towards ceramics. Researchers are also working on polysulfone, polyacrylonitrile, polyolefins and engineering polymers such as PEEK, which a 2025 review describes as resistant to acids, alkalis and organic solvents but in need of hydrophilic modification.
What a replacement has to prove
PVDF's strength is that it survives years of cleaning with hypochlorite and caustic. A replacement must be tested on the same points:
Pore structure: pore size distribution and bubble point on a capillary flow porometer.
Permeability and rejection: clean water flux and molecular weight cut-off.
Mechanical strength: tensile strength and elongation of fibres on a tensile tester.
Surface: hydrophilicity on a contact angle meter.
Chemical ageing: repeated exposure to cleaning chemicals, then all the above again. See our guide to hypochlorite ageing tests.
Making the samples
New polymers mean new dopes, solvents and spinning conditions. Our flat-sheet casting machines and hollow fibre spinning lines let a lab make membranes from candidate polymers under controlled conditions, so the comparison with PVDF is fair.
Write to mail@techincresearch.com or call +1 (289) 622-1032.
Equipment specifications are typical and may change. Test results depend on the membranes, waters and conditions tested, how the equipment is used and operation in line with the operation manual.
Sources
European Parliamentary Research Service, Per- and polyfluoroalkyl substances: Tackling 'forever' chemical pollution, briefing, July 2026.
The MBR Site, Dr Graeme Pearce, PVDF membranes and PFAS: what impact of the EU's REACH legislation?.
Membranes 15(9) 256 (2025), Zhou et al., Recent Progress on the Development of Polyetheretherketone Membranes for Water Remediation.





Comments