Pressure Leaf Filters Explained: Precoat, Body-Feed, Cake Drying and Discharge

At a glance. A pressure leaf filter is a closed vessel holding a stack of flat filter leaves covered with fine stainless mesh. The mesh alone is too open to hold fine solids, so a thin layer of filter aid is built on it first. The liquor is then pumped through the leaves until the cake is full, the cake is blown dry, and it is discharged. The cycle repeats with little labour and no open handling.
One filtration cycle
Fill and precoat. Clean liquor or water with filter aid, often about 1 to 2 kg per square metre of diatomaceous earth, perlite or cellulose, is circulated until the aid forms an even layer on the mesh and the filtrate runs clear.
Filtration with body-feed. The process liquor is pumped through the leaves. A small dose of filter aid is added continuously so the growing cake stays porous and the pressure rises slowly.
Heel recovery. When the cake is full or the pressure reaches its limit, the liquor left in the vessel is pushed through a heel filter or returned to the feed tank.
Cake drying. Air, nitrogen or steam blows through the cake to remove liquor and leave it dry enough to handle.
Discharge. A vibrator shakes the cake off the leaves into a bottom outlet, or water sprays sluice it out as a slurry.
Design choices
Vertical or horizontal tank. Vertical filters are compact; horizontal filters have a leaf bundle that slides out for inspection and cleaning.
Leaf spacing. Sets the maximum cake thickness and therefore the cycle length.
Hermetic build. Needed for solvents and catalysts: fully closed, nitrogen for drying, Ex-rated equipment.
Twin filters. One filters while the other is cleaned, for continuous plants.
Polishing filter. A cartridge or bag filter after the leaf filter catches any filter-aid fines.
Where leaf filters are used
Edible oil bleaching and dewaxing, gelatin and collagen liquors, sugar and glucose syrups, sorbitol after catalyst removal, and chemical and pharmaceutical liquors.
Where Tech Inc. equipment fits
Tech Inc. builds the pressure leaf filter skid, the closed catalyst candle filter skid and the edible oil polishing filtration skid.
Related reading
Sources
This guide is general information. Filter aid, area and cycle are chosen from filtration tests on the client's liquor.





Comments