Application Note: Running Second-Generation Ethanol and Lactic Acid Trials at Pilot Scale

At a glance. Second-generation ethanol is made from straw, bagasse and other residues rather than from sugar or grain. Lactic acid, the building block of PLA bioplastic, is made by fermenting sugars. Both are developed at pilot scale before a plant is built, and the pilot must reproduce the real steps and record what scale-up needs.
The steps
Pretreatment. Biomass is heated with steam, often with dilute acid, under pressure for a few minutes and then flashed, which opens the fibre so enzymes can reach the cellulose.
Enzymatic hydrolysis. Cellulase enzymes break the cellulose into sugars over one to three days at moderate temperature and controlled pH, in a thick slurry that needs a strong agitator.
Fermentation. Yeast turns the sugars into ethanol; lactic acid bacteria turn them into lactic acid, with pH held by adding an alkali.
Separation and recovery. Solids are removed, then ethanol is distilled, or lactic acid is purified through filtration, ion exchange, evaporation and, for PLA grade, distillation.
What the rig must record
Temperature, pressure and time at pretreatment, and the severity they add up to.
pH, temperature, agitator power and solids loading during hydrolysis.
Fermentation temperature, pH, base added, gas flow and, where used, dissolved oxygen.
Mass balances: what went in and what came out of each step.
Practical points
Steam and pressure need relief devices and interlocks; slurries need wide nozzles and valves that do not block; fermenters need steam sterilisation and aseptic sampling; and the control system should export data in a form the scale-up team can use.
Where Tech Inc. equipment fits
Tech Inc. builds the pilot bio-refinery rig, pressurised gas-fermentation reactors, bioreactor gas panels and exhaust condensers and the falling-film solvent recovery skid.
Related reading
Sources
Humbird, D. et al. (2011). Process Design and Economics for Biochemical Conversion of Lignocellulosic Biomass to Ethanol, NREL/TP-5100-47764 – National Renewable Energy Laboratory
Biomass compositional analysis laboratory procedures – National Renewable Energy Laboratory
This note is general information. Each rig is configured to the research programme and feedstocks.





Comments