top of page

Pervaporation Calculations: Flux, Separation Factor and the Pervaporation Separation Index, Worked Through

Writer: Tech Inc
Tech Inc
1 day ago
2 min read

Pervaporation separates liquid mixtures through a dense membrane, with the permeate drawn off as vapour under vacuum and condensed in a cold trap. If you are new to it, start with what pervaporation is. This guide covers the three numbers used to judge a membrane.

1. Flux

J = m ÷ (A × t)

  • m: mass of permeate collected in the cold trap.

  • A: effective membrane area.

  • t: collection time.

2. Separation factor

For a binary mixture of A (the faster component) and B:

α = (yA ÷ yB) ÷ (xA ÷ xB)

where y is the permeate composition and x the feed composition, as mass or mole fractions (state which).

3. Pervaporation separation index

PSI = J × (α − 1)

PSI combines flux and selectivity in one figure. A 2021 review lists both J × α and J × (α − 1) in use, so always state which form you report.

Worked example: ethanol dehydration (illustrative numbers)

  • Feed: 10 wt% water, 90 wt% ethanol.

  • Membrane area: 20 cm² (0.0020 m²).

  • Permeate collected: 12.0 g in 2 hours; analysed at 90 wt% water.

Flux: J = 0.012 kg ÷ (0.0020 m² × 2 h) = 3.0 kg/(m²·h)

Separation factor: α = (0.90 ÷ 0.10) ÷ (0.10 ÷ 0.90) = 81

PSI = 3.0 × (81 − 1) = 240 kg/(m²·h)

Testing tips

  • Steady state first. Discard the first collection; the membrane swells and the cold trap equilibrates.

  • Weigh the trap, not just the liquid. Some permeate freezes on the trap walls.

  • Control temperature. Flux rises sharply with feed temperature; report it.

  • Watch the feed composition. In small batch tests the feed changes as water leaves; keep runs short or top up.

  • Analyse with the right method: water by Karl Fischer titration, organics by gas chromatography or refractive index.

Equipment

The Lab Pervaporation Test Skid and SS 316 pervaporation test cell include vacuum, cold trap and temperature control. See the full range on Pervaporation Testing Systems.

Write to mail@techincresearch.com or call +1 (289) 622-1032.

Worked examples use illustrative numbers. Equipment specifications are typical and may change; results depend on the membranes and conditions tested, how the equipment is used and operation in line with the operation manual.

Sources

Comments


bottom of page