top of page

Materials for Hot Caustic: Nickel 200, Nickel 201, Alloy 600 and Why Stainless Steel Cracks

Writer: Tech Inc
Tech Inc
5 days ago
2 min read

At a glance. Caustic soda is mild at room temperature but aggressive when hot and concentrated. Carbon steel and austenitic stainless steels suffer caustic stress-corrosion cracking and general attack as temperature and concentration rise, which is why reactors for caustic fusion, caustic evaporators and molten-caustic equipment are built in nickel or high-nickel alloys.

What goes wrong with ordinary steels

  • Carbon steel. Usable in cooler, more dilute caustic; above the limits set by caustic service charts it cracks at welds and other stressed areas unless it is stress relieved, and in hot concentrated caustic it is unsuitable. Refinery practice such as NACE SP0403 sets out where stress relief is needed.

  • Austenitic stainless steels. 304 and 316 can crack in hot caustic, especially where caustic concentrates at crevices, under deposits or at the liquid line.

  • Duplex steels. Better than austenitic grades in some alkaline duties, but not a substitute for nickel in molten or very hot concentrated caustic.

The nickel family

  • Nickel 200. Commercially pure nickel, the classic material for caustic evaporators and handling. It is limited to service below about 315 °C because carbon can precipitate as graphite and embrittle it at higher temperature.

  • Nickel 201. The low-carbon version of Nickel 200, used above about 315 °C, for example in caustic fusion and molten-caustic equipment.

  • Alloy 600. A nickel–chromium–iron alloy with excellent resistance to alkaline solutions and to oxidising conditions, and higher strength at temperature. Its maker notes that it can suffer stress-corrosion cracking in very hot, strong caustic, so it is chosen with care for those duties.

  • Alloy 625 and C-276. Used for trim, agitators or parts that also see chlorides or acids.

Fabrication points

  1. Weld procedures are qualified for the exact grade and thickness, with matching nickel filler metals.

  2. Cleanliness matters: sulphur, lead and other low-melting contaminants must be kept away from nickel during welding and heat treatment.

  3. Design avoids crevices and stagnant zones where caustic can concentrate.

  4. Inspection includes radiography of pressure welds, positive material identification and hydrotesting to the code.

Typical equipment

Caustic-fusion reactors for sebacic acid and 2-octanol, caustic concentrators and evaporators, molten-salt and caustic melt pots, and heat exchangers on hot caustic duties.

Where Tech Inc. equipment fits

Tech Inc. builds the nickel-alloy caustic-fusion reactor and special-alloy process vessels, and welds nickel alloys in its own workshop, as it does for Monel hydrofluoric acid equipment.

Related reading

Sources

This guide is general information. Materials are selected for each duty from the process conditions, the licensor's rules and the applicable codes.

Comments


bottom of page