Inside a Lube and Grease Plant: Blending, Additive Dosing, Filtration and Grease Making

At a glance. A finished lubricant is mostly base oil with an additive package dosed to a recipe. Blending plants make dozens of grades from the same tanks, so the equipment has to weigh or meter accurately, keep grades apart, handle thick additives and record every batch. Grease plants add a chemical step: the soap is made in a pressure contactor, then finished in a kettle and milled.
Blending: batch or in-line
Recipe. The operator or the plant's ERP selects the grade and the batch size.
Components. Base oils and additives are either weighed into a blend vessel on load cells (automatic batch blending) or metered by Coriolis meters into a moving stream (in-line blending).
Mixing. An agitator or static mixer blends the components at the set temperature; heating keeps heavy base oils and additives moving.
Release. A sample is tested, the blend is released to a finished-product tank and the lines are cleared by air blowing or pigging.
Batch blending suits many grades in small lots; in-line blending suits large volumes of fewer grades. Many plants run both.
Additives: small volumes, large effect
Additives are a small share of a lubricant by volume but most of its cost and performance. Viscosity modifiers and some packages are very thick, so they are stored in heated day tanks and dosed through heated lines. Very small or very viscous additives are often premixed with base oil first, which makes the final dose more even and more accurate.
Final filtration and filling
The last chance to remove particles and water is between the finished tank and the container. A filtration and filling skid pumps the oil through bag or cartridge filters and fills drums, IBCs and pails on a scale, fast and then slowly to the set weight. Filling by weight cuts give-away, and every fill is recorded against the batch.
Making grease
Saponification. Base oil, a fatty acid and a metal hydroxide react in a pressure contactor, which runs hotter and faster than an open kettle.
Finishing. The soap is dropped into a kettle with scraper agitators, cut back with base oil and cooled on a set profile.
Milling. A homogeniser or mill gives the final texture; a deaerator removes air before filling.
Where Tech Inc. equipment fits
Tech Inc. builds the lube oil blending skid, the lube additive dosing and premix skid, the finished lube filtration and drum filling skid and the grease contactor and kettle skid, as well as the bulk oil storage and dispensing work centre for the users of those lubricants.
Related reading
Sources
This guide is general information. Each plant is designed to its products, recipes, capacity and site rules.





Comments