top of page

Hollow Fibre Membranes: Structure, Materials and How They Are Made

Writer: Tech Inc
Tech Inc
4 days ago
2 min read

At a glance. A hollow fibre membrane is a fine tube whose wall is the membrane. Fibres for water treatment are typically 0.5 to 2 mm in outside diameter; gas separation and dialysis fibres are finer. Thousands of fibres potted into one housing give a very large membrane area in a small volume. Tech Inc. supplies hollow fibre membranes for research and the machines that make them.

Structure

  • A lumen (the bore) runs down the centre.

  • The wall is usually asymmetric: a thin selective skin on the inner or outer surface over a more open support layer.

  • Braid-reinforced fibres coat the membrane onto a textile braid for strength in membrane bioreactors.

Materials

  • Polyethersulfone and polysulfone: UF for water, food and biopharma.

  • PVDF: chemically robust UF and MF, widely used in MBR.

  • Polyacrylonitrile and cellulose acetate: UF and specialist uses.

  • Polypropylene and polyethylene: MF and membrane contactors.

  • Polyimides and other glassy polymers: gas separation.

  • Ceramics: for harsh chemistry and high temperature.

How hollow fibres are made

  1. Dry-jet wet spinning (NIPS). Polymer dope and a bore fluid are pumped through a tube-in-orifice spinneret. The nascent fibre passes through an air gap into a coagulation bath, where phase inversion forms the porous wall.

  2. Thermally induced phase separation (TIPS). For PVDF and polyolefins, the polymer is dissolved hot and the fibre forms as it cools.

  3. Melt spinning and stretching. Polypropylene and polyethylene fibres are melt spun and then stretched to open the pores.

Fibre size and pore structure depend on dope composition, bore fluid, air gap, take-up speed and bath temperature. See our guide to hollow fibre spinning parameters.

Inside-out and outside-in

  • Inside-out: feed flows through the lumen. A well-defined flow channel suits low-solids feeds.

  • Outside-in: feed is on the shell side. It tolerates higher solids and suits submerged and MBR systems.

Where hollow fibre membranes are used

  • Drinking water and wastewater ultrafiltration.

  • Membrane bioreactors.

  • Haemodialysis.

  • Nitrogen generation and gas separation.

  • Membrane contactors, degassing and humidifiers.

  • Cell culture bioreactors.

From fibre to module

Fibres are bundled, potted in resin, cut open and tested. See our guide to hollow fibre membrane modules, the lab module housing kits and the module integrity tester. To compare formats, read hollow fibre vs flat sheet membranes.

Frequently asked questions

What is the difference between a hollow fibre membrane and a hollow fibre module? The membrane is the fibre itself; the module is the housing with thousands of potted fibres.

Can I spin hollow fibres in the lab? Yes. A lab spinning line with a spinneret, dope and bore-fluid pumps, coagulation bath and take-up winder makes research fibres; see the pilot hollow fibre spinning line for scale-up.

Send your requirements to mail@techincresearch.com or call +1 (289) 622-1032.

Comments


bottom of page