Process Note: Green Hydrogen Production, from Feed Water to Dry Gas

At a glance. Water electrolysis splits water into hydrogen and oxygen using electricity, ideally from renewable sources. Each kilogram of hydrogen consumes about 9 kg of water in theory, and more in practice once treatment rejects and cooling are counted. Impurities in that water poison catalysts and membranes, so the feed water is purified to a very high standard. The hydrogen that leaves the stack is wet and carries traces of oxygen, so it is purified and dried before compression, storage or use. Green hydrogen projects across the world, from Europe to the Middle East, India and Australia, follow the same general pattern.
Feed water treatment
Raw water: municipal water, groundwater, desalinated seawater or treated wastewater.
Pretreatment: media or cartridge filtration, with softening or antiscalant as needed.
Reverse osmosis, often in two passes, removing most dissolved salts.
Electrodeionisation (EDI), which polishes the RO permeate to high resistivity without regeneration chemicals.
Polishing in the stack water loop. PEM electrolysers commonly use an ion exchange polisher in the recirculating water loop to hold conductivity down. Alkaline electrolysers use demineralised water to make up their potassium hydroxide electrolyte.
Gas treatment
Gas–liquid separation, removing entrained water or electrolyte.
Cooling and condensate removal.
Deoxo: a catalytic reactor converts traces of oxygen into water.
Drying: temperature-swing or pressure-swing adsorption dryers reduce water to the required dew point.
Compression, storage and pressure reduction to the user.
Quality checks against the application: ISO 14687 for fuel cell vehicles and other uses, or the customer's own specification for industry.
Design points
Water quality targets from the electrolyser maker, usually stated as conductivity or resistivity, with limits for silica, total organic carbon and metals.
Water availability, including disposal of RO reject.
Variable operation, as renewable power ramps the electrolyser up and down and the water and gas trains must follow.
Hydrogen safety: ventilation, gas detection, hazardous area classification and materials suited to hydrogen.
Sampling that does not contaminate the sample, particularly for ISO 14687 trace contaminants.
Common problems
Rising stack voltage or faster degradation traced to water quality excursions.
Silica or iron carried through when RO or EDI units are not maintained.
Oxygen in the hydrogen after deoxo catalyst problems or during low-load operation.
Wet hydrogen after dryer regeneration faults.
Sampling errors that report contamination the gas does not have, or miss contamination it does have.
Where Tech Inc. equipment fits
Tech Inc. supplies electrolyser and fuel cell systems for research and pilot work, small and medium electrodeionisation systems, purified water generation skids with RO and EDI, the hydrogen fuel quality sampling kit (ISO 14687), hydrogen and industrial gas pressure reducing stations and LPG, LNG and hydrogen sampling systems.
Related reading
This note is general guidance. Water and gas quality limits follow the electrolyser maker's requirements and the end user's specification.





Comments