top of page

ASTM D6304 Explained: Water in Lubricating Oils, Hydraulic Fluids and Petroleum Products by Coulometric Karl Fischer Titration

Writer: Tech Inc
Tech Inc
6 minutes ago
2 min read

ASTM D6304, Standard Test Method for Determination of Water in Petroleum Products, Lubricating Oils, and Additives by Coulometric Karl Fischer Titration (D6304-25) is the reference method for low water content in oils. ASTM's scope describes the direct determination of entrained water by automated coulometric instrumentation (Procedure A), and the indirect analysis of water driven off thermally and swept by dry inert gas into the titration cell (Procedures B and C), with precision stated from about 20 mg/kg up to 25,000 mg/kg depending on the procedure.

What it covers

The scope lists additives, lube oils, base oils, automatic transmission fluids and hydrocarbon solvents, and warns that mercaptans, sulphides, hydrogen sulphide and other compounds interfere. The oven procedures exist for exactly those samples: the water is evaporated away from the interfering matrix before it reaches the reagent.

Our commentary: what the number means

  • Dissolved, emulsified, free. Oil holds a few hundred ppm of water in solution at operating temperature; above saturation it turns cloudy and then separates. Bearing life falls steeply once water exceeds saturation, so the target is well below it, typically a few hundred ppm for turbine and hydraulic oils and lower for transformer oil.

  • Sample handling decides the result. Water migrates to the bottle wall and the headspace; a cold sample reads lower than the oil in the machine. Fill the bottle full, test promptly, shake before drawing.

  • Removing water is a vacuum-dehydration or coalescing job, not a filtration job: fine filters remove particles, a vacuum dehydrator removes dissolved and free water and gases. Our hydraulic oil dehydrator combines both.

  • Transformer oil has its own Karl Fischer practice (ASTM D1533), and the dissolved-gas analysis sample must be taken without air contact; see our DGA sampling kit.

Our equipment

Send your application, materials and the standards your contract names to mail@techincresearch.com or call +1 (289) 622-1032, and we will return a configuration, datasheet and quotation.

This article is our commentary on the standard's published scope, not a substitute for the standard itself; always work to the current edition named in your contract. Equipment specifications may change; performance depends on the application, how the equipment is used and operation in line with the operation manual.

Sources

Comments


bottom of page