top of page

Membrane Coating Machine: Inside the Tech Inc. Automatic Film Applicator

Writer: Tech Inc
Tech Inc
Nov 13
2 min read

Updated: 7 days ago

At a glance. A membrane coating machine spreads a polymer solution or slurry into a film of exact, even thickness. These are real photos of the Tech Inc. Automatic Film Coater with Heated Vacuum Bed, our film applicator and membrane coating machine, built and factory-tested in Chennai. It holds the substrate flat by vacuum, draws the applicator at a constant speed and dries the film under a heated cover, so every film comes out the same.

Tech Inc. membrane coating machine (automatic film applicator) with heated drying cover

The Tech Inc. automatic film applicator with its drying cover raised.

What a membrane coating machine does

Flat sheet membranes start as a thin, even layer of polymer solution spread on glass or a nonwoven support, which is then turned into a porous membrane by phase inversion. Battery laboratories use the same method to coat electrode slurries onto foil. In both cases the wet film thickness decides the result: membrane flux and pore structure, or electrode loading and capacity. Coating by hand gives a different film every time; a machine gives the same film every time.

The machine, part by part

Control panel

Front control panel of the Tech Inc. film applicator: touch screen, temperature controller and emergency stop

Colour touch screen, digital temperature controller and emergency stop on the front panel.

Coating speed and stroke are set on the colour touch screen, and the bed temperature on its own digital controller, so the same settings can be repeated film after film. A red emergency stop sits within easy reach.

Vacuum bed and film applicator

Vacuum bed and motorised film applicator inside the Tech Inc. membrane coating machine

Cover open: the flat vacuum bed and the motorised applicator carriage.

The vacuum bed holds glass plates, foils and nonwoven sheets flat, so the gap under the applicator stays the same across the whole film. A motorised carriage draws the applicator at a constant speed; a fixed-gap or micrometer applicator sets the wet film thickness.

Heated drying cover

Heated drying cover with cooling fans on the Tech Inc. film coater

The hinged drying cover, with fans on top.

For films that must dry before they are moved, the cover closes over the coated film and the heated bed and cover dry it in place. The cover lifts on a handle and stays open while the next substrate is loaded.

Built for daily laboratory use

Rear and side of the Tech Inc. membrane coating machine showing service connections

Steel cabinet on levelling feet, with service connections at the rear.

A steel cabinet on levelling feet keeps the bed level on any bench, and the electrical and service connections are kept at the rear, away from the coating area.

Choosing a membrane coating machine

  • Coating width and length: set by the largest membrane or electrode you need to cast.

  • Wet film thickness: choose fixed-gap or micrometer applicators to cover your range.

  • Substrate: glass plate, metal foil or nonwoven support, all held flat by the vacuum bed.

  • Drying: a heated bed alone, or with the heated drying cover.

  • Solvents and atmosphere: a compact version fits inside a glove box for moisture-sensitive work.

Get the datasheet or a quotation

Download the datasheet (PDF) or see the product page. For a quotation, send the coating width, the thickness range, the substrate, the drying temperature and the solvents you use to mail@techincresearch.com.

Comments


bottom of page