top of page

Membrane Casting: Process, Methods and the Parameters That Matter

Writer: Tech Inc
Tech Inc
4 days ago
2 min read

At a glance. Membrane casting spreads a polymer solution, the dope, into a film of controlled thickness and turns it into a porous membrane, usually by phase inversion. Film thickness, dope composition, evaporation time, humidity and the coagulation bath decide the final structure. Tech Inc. casting machines make each of these repeatable, from lab plates to continuous rolls.

The casting process, step by step

  1. Dope preparation. A polymer such as polysulfone, polyethersulfone, PVDF, polyacrylonitrile or cellulose acetate is dissolved in a solvent such as NMP, DMAc or DMF, often with pore formers such as PVP or PEG. The dope is mixed, filtered and degassed.

  2. Casting. A doctor blade set to a fixed gap spreads the dope onto a glass plate or a non-woven support at a controlled speed.

  3. Evaporation. The film spends a set time in air before immersion. Solvent loss and moisture uptake in this step shape the skin layer.

  4. Coagulation. The film enters a non-solvent bath, usually water. Solvent and non-solvent exchange, the solution separates into polymer-rich and polymer-poor phases, and the porous structure forms.

  5. Post-treatment. Rinsing removes residual solvent; annealing or glycerol treatment stabilises the pores for storage.

Casting methods

  • Non-solvent induced phase separation (NIPS): immersion in a non-solvent bath. The standard route for UF and MF membranes; read our phase inversion guide.

  • Vapour induced phase separation (VIPS): the film is exposed to humid air before or instead of immersion, giving more open, symmetric structures.

  • Thermally induced phase separation (TIPS): the polymer is dissolved at high temperature and the film is cooled. Used for PVDF and polyolefins.

  • Evaporation (dry) casting: the solvent evaporates completely, leaving a dense film for gas separation or pervaporation studies.

  • Composite membranes: a porous support is cast first and a thin selective layer is coated on top, for example by interfacial polymerisation.

The parameters that matter

  • Blade gap, which sets the wet film thickness.

  • Casting speed, which affects shear and thickness uniformity.

  • Polymer concentration and dope viscosity.

  • Dope and plate temperature.

  • Evaporation time before immersion.

  • Relative humidity around the film; see why humidity matters.

  • Bath composition and temperature.

  • Support fabric, if one is used.

From lab plates to roll casting

Frequently asked questions

Is membrane casting the same as phase inversion? No. Casting forms the film; phase inversion is the mechanism that turns the film into a porous membrane.

Why do my membranes vary from batch to batch? The usual causes are changes in humidity, dope ageing or viscosity, evaporation time and blade gap. Control these and the variation drops sharply.

Can I cast on a non-woven support in the lab? Yes. Roll casters and plate casters both take a support fabric.

Send your requirements to mail@techincresearch.com or call +1 (289) 622-1032.

Comments


bottom of page