top of page

MBR Design Parameters: What to Measure in Lab and Pilot MBR Studies

Writer: Tech Inc
Tech Inc
4 days ago
2 min read

At a glance. A membrane bioreactor (MBR) design rests on a few parameters: membrane flux, mixed liquor suspended solids (MLSS), sludge retention time (SRT), hydraulic retention time (HRT), food-to-microorganism ratio (F/M) and air scour demand. The typical ranges below are starting points; lab and pilot MBR tests confirm them for a specific wastewater.

The design parameters

  • Flux. Submerged MBRs typically run at a net flux of about 10 to 25 L/m²·h for municipal wastewater, with higher peak flux for short periods. Industrial wastewaters often need lower values.

  • MLSS. Typically 8 to 12 g/L in the membrane tank. Higher MLSS cuts tank volume but raises viscosity and aeration demand.

  • SRT. Often 15 to 30 days or more. Long SRT supports nitrification and reduces sludge production.

  • HRT. Set by the organic and nitrogen load; for municipal plants, often a few hours to under a day.

  • F/M. Low, typically around 0.05 to 0.15 kg BOD per kg MLVSS per day.

  • Air scour. Expressed as specific aeration demand per membrane area (SADm) or per permeate volume (SADp). It is a major share of MBR energy use.

Operating cycle

  • Filtration periods of several minutes, followed by relaxation or a short backpulse.

  • Maintenance cleans at short intervals, recovery cleans every few months.

  • Test chemically enhanced backwash routines on a backwash and CEB testing system.

What lab and pilot tests tell you

  • Critical and sustainable flux for your mixed liquor.

  • How quickly fouling builds at each flux and air scour rate.

  • How effective each cleaning step is.

  • Effluent quality at the chosen SRT and HRT.

Tech Inc. MBR test systems

Frequently asked questions

What flux should I design for? Use the sustainable flux measured on your wastewater, with a margin. Literature values are only a starting point.

Flat sheet or hollow fibre? Both are used at full scale. Flat sheet modules are simple to clean; hollow fibre modules pack more area into a tank. Testing both on your wastewater settles the choice.

Send your requirements to mail@techincresearch.com or call +1 (289) 622-1032.

Comments


bottom of page