The Tech Inc. Silton 4950 PRO-E Automatic SDI Analyser with Ethernet is the Silton 4950 Pro with Ethernet built in. It runs the same unattended ASTM D4189 test with automatic filter-roll change, and adds a factory-fitted Ethernet port (Modbus TCP) to the RS-485 Modbus RTU link, the 4–20 mA output and three relay outputs, so SDI results reach a SCADA network, a pilot-plant data system or a remote dashboard without an extra gateway.
At a glance: Ethernet Modbus TCP · RS-485 Modbus RTU · 4–20 mA · three relays · automatic filter-roll change · ASTM D4189
Main components
- Automatic filter-roll drive and filter head, 0.45 µm, 47 mm test area
- Booster pump and regulator holding 2.07 bar (30 psi)
- PLC controller with 7-inch colour touch screen and data log
- Ethernet port, Modbus TCP (factory fitted)
- RS-485 Modbus RTU, 4–20 mA output and three relay outputs
- IP55 wall cabinet with cable glands for power, signal and network
Applications: RO pilot plants and research test beds that log everything on a network, plants with Ethernet-based SCADA, and sites that view SDI remotely.
Send your water source, sample points and signal requirements to mail@techincresearch.com or call +1 (289) 622-1032 for a datasheet and quotation.
Silton 4950 PRO-E Automatic SDI Analyser with Ethernet
- Single channel – one sample point (standard).
- Dual channel – two sample points.
- GRP cabinet – for coastal and outdoor sites.
- 316L wetted parts – for filtered seawater.


