top of page

How to Saturate Core Plugs Completely

Writer: Tech Inc
Tech Inc
6 hours ago
1 min read

At a glance. A core saturator evacuates dry cores in a sealed vessel, lets brine or oil flood them under vacuum, then pressurises the vessel so that trapped gas dissolves and fine pores fill. The Tech Inc. Core Saturator does both steps in one vessel.

Why vacuum alone is not enough

Vacuum removes most air, but bubbles trapped in small or dead-end pores can remain. Raising pressure to 100 bar or more dissolves them and pushes liquid into the smallest pores.

Procedure

  1. Clean and dry the cores; record dry weights.

  2. Evacuate the vessel with the cores for several hours.

  3. Admit de-aired brine under vacuum until the cores are covered.

  4. Pressurise and hold, typically overnight.

  5. Release slowly, weigh the cores saturated and in brine.

  6. Check: pore volume by weight against helium porosity.

Frequently asked questions

Which brine? Synthetic formation brine, de-aired and filtered.

How do we know saturation is complete? Liquid-saturation pore volume should match helium pore volume within a few percent.

Pair it with our capillary pressure and resistivity systems. Contact mail@techincresearch.com.

Comments


bottom of page