top of page

Core Flooding Systems: What They Measure and How to Specify One

Writer: Tech Inc
Tech Inc
6 hours ago
1 min read

At a glance. A core flooding system drives brine, oil, gas or chemicals through a rock plug at reservoir pressure and temperature while it measures pressure drop and produced fluids. The Tech Inc. Core Flooding System combines a Hassler core holder in an oven, pulse-free syringe pumps, transfer vessels and a dome-loaded back pressure regulator.

Typical tests

Test

Result

Absolute permeability

Darcy permeability to brine

Steady-state or unsteady-state relative permeability

kr curves for oil, water and gas

Waterflood and chemical EOR

recovery factor, residual oil

CO2 and gas injection

displacement efficiency, injectivity

Formation damage and acidising

return permeability

The main components

  • Core holder with a rubber sleeve and confining pressure.

  • Pumps: dual-cylinder syringe pumps for steady, pulse-free flow.

  • Transfer vessels that keep corrosive or live fluids away from the pumps.

  • Back pressure regulator to hold pore pressure and keep gas in solution.

  • Measurement: differential and absolute transducers, effluent balance or separator.

Specification checklist

  1. Core sizes and lengths.

  2. Maximum pore and confining pressure, and temperature.

  3. Fluids (brine, dead or live oil, CO2, polymer, acid) and wetted materials.

  4. Flow range of each pump.

  5. Effluent measurement and analysis.

  6. Data logging and safety requirements.

Frequently asked questions

Why a dome-loaded BPR? It controls pressure smoothly at very low flows and with two-phase fluids. See our back pressure regulators.

Can the same rig do formation damage tests? Yes, with reverse-flow valves and return permeability steps.

Send your test programme to mail@techincresearch.com.

Comments


bottom of page