top of page

Burst Pressure Testing: Methods, Standards and Equipment

Writer: Tech Inc
Tech Inc
5 hours ago
1 min read

At a glance. A burst test raises pressure at a controlled rate until the part fails; a proof test holds a set pressure, usually a multiple of working pressure, without failure. The Tech Inc. Automated Burst Pressure Tester runs both in a guarded chamber with recorded results.

Burst and proof

Test

Purpose

Typical pressure

Proof

production check without damage

often 1.5 to 2 times working pressure

Burst

design verification

often 4 times working pressure for hoses

Standards often used

  • ISO 1402 and SAE J343 for hoses and hose assemblies.

  • ISO 6605 for hydraulic hose assemblies.

  • Product standards for filters, vessels and fittings.

Safety

  • Liquid, not gas, for high pressures: stored energy is far lower.

  • Bleed all air from the part.

  • Test in a guarded chamber with door interlock.

  • Never stand in line with an end fitting.

What to specify

  1. Maximum pressure and ramp rates.

  2. Part sizes and connections.

  3. Test media and temperature.

  4. Records and certificates required.

Frequently asked questions

Gas burst tests? Possible in a reinforced chamber with small volumes; liquid is preferred whenever the part allows.

Can it do cyclic tests? For fatigue, use our cyclic pressure test system.

Comments


bottom of page