top of page

Testing Battery Cell Vents and Can Burst Pressure

Writer: Tech Inc
Tech Inc
5 hours ago
1 min read

At a glance. In thermal runaway, gas pressure builds inside a cell. The vent must open within a narrow pressure band: too low and cells leak in service, too high and the can may rupture. The Tech Inc. Battery Cell Burst and Vent Pressure Tester seals an empty can or cap assembly in a fixture, ramps pressure and records the vent and burst points.

What is tested

Component

Measurement

Cylindrical cap (CID and vent)

current interrupt and vent opening pressure

Cylindrical can

burst pressure

Prismatic cap plate

vent opening pressure

Pouch

seal strength under pressure

Good practice

  • Fast logging to catch the pressure peak at the vent event.

  • Controlled ramp rate, the same for every sample.

  • Fixtures that seal without loading the vent.

  • Enclosed test area, even for empty components.

Frequently asked questions

Gas or liquid? Gas for vent opening near service conditions; liquid for higher burst pressures.

Sampling plan? Usually per lot, with statistics on vent pressure spread.

Comments


bottom of page