top of page

Automated Gas Pressure Control for Test Rigs

Writer: Tech Inc
Tech Inc
4 hours ago
1 min read

At a glance. An automated pressure controller compares a high-accuracy pressure reading with the set point and drives inlet and exhaust valves to close the gap, many times a second. The Tech Inc. Automated Gas Pressure Control System follows set points, ramps, holds and cycles, and logs every value.

Where it is used

  • Porometers, permeameters and integrity testers.

  • Membrane and filter test rigs.

  • Reactor and pilot plant pressure control.

  • Sensor, gauge and switch testing.

Choosing a controller

Question

Why it matters

Pressure range

accuracy is usually a percentage of full scale

Control stability

how close the pressure stays to set point

Speed

how fast it reaches and settles at each step

Gas and volume

larger volumes need higher flow valves

Interfaces

Ethernet, Modbus or analogue to your rig

Good practice

  • Choose the smallest range that covers the test.

  • Filter the supply gas.

  • Keep connected volumes small for faster control.

Frequently asked questions

Can it control vacuum? Yes, with a vacuum source and a suitable range.

Hydraulic pressure? See our automated hydraulic pressure control system.

Comments


bottom of page