The Tech Inc. Automated Clean Water Flux QC Tester tests clean water flux and rejection of up to eight membrane coupons at the same time, so membrane manufacturers can check every roll. Pressure and temperature are controlled automatically, permeate flow is measured for each cell, and results are corrected to 25 °C and reported per coupon.

Main components

Eight flat-sheet test cells on a common manifold
Feed tank with temperature control and pump
Permeate flow measurement for each cell
Automatic pressure control and conductivity for rejection
Control panel with recipes, data logging and coupon reports

Applications: Quality control in MF, UF, NF and RO membrane manufacturing, and screening of new membranes in research.

Send your membrane type, test conditions and sample size to mail@techincresearch.com or call +1 (289) 622-1032 for a configuration, datasheet and quotation.

Automated Clean Water Flux QC Tester

Four-cell tester – smaller laboratories.

Eight-cell tester – production QC.

Twelve-cell tester – high-throughput lines.
Cells: 4, 8 or 12

Pressure: up to 41 bar (RO) or 6 bar (UF)

Temperature: controlled at 25 °C

Outputs: flux, permeability, rejection, per coupon
High throughput – eight coupons in one run.

Consistent – same pressure and temperature on every cell.

Automatic reports – results per coupon and per roll.

Flexible – MF to RO with the right cells.
Established manufacturer – part of the Davey Group since 1990, exporting to more than 110 countries.

Everything under one roof – in-house mechanical fabrication, electrical works, PLC and SCADA automation, and R&D.

Complete scope – design, supply, installation, commissioning, factory acceptance testing (FAT) and site acceptance testing (SAT).

Trusted by Saudi Aramco – an established supplier to Saudi Aramco.

Certified management systems – ISO 9001, ISO 14001 and ISO 45001, with CE marking.

Close to your project – offices in Chennai (India), Toronto (Canada), Tallinn (Estonia) and Al Khobar (Saudi Arabia).

For this product – we build membrane casting lines, so we understand the QC step that follows them.
Engineering to your P&ID, data sheets and company standards; drawings submitted for approval before manufacture; factory acceptance testing (FAT) with client or third-party inspection; export packing and full documentation dossier; installation, commissioning and site acceptance testing (SAT); operator training, spares and after-sales support worldwide. Contact mail@techincresearch.com or +1 (289) 622-1032.
Clean Water Flux QC: Testing Every Membrane Roll Without Slowing Production

Data Acquisition and Control in Membrane Test Systems: What to Log and Why
Crossflow Membrane Test Cell (42 cm²) – single crossflow cells.

Filter and Membrane Integrity Tester – integrity testing.

Membrane Fouling Simulator (MFS) – fouling simulation.